Raise your 1995-1999 Chevrolet Tahoe / GMC Yukon 4-Door 2WD 5.7L gasoline V8 with this 7-inch front / 5-inch rear lift kit. The front uses 4-inch lift spindles and coil spacers, while the rear uses lift blocks and the included Grade 8 U-bolt set. This version includes all four shocks and mounting hardware.
4-door 2WD only. 5.7L gasoline V8. Measure the front rotor: approximately 1.25-inch thickness required.
Vehicle fitment
- 1995-1999 Chevrolet Tahoe 2WD
- 1995-1999 GMC Yukon 2WD
Fitment notes
- 1995-1999 Chevrolet Tahoe and GMC Yukon full-size 4-door models with 2WD and coil-spring front suspension. Does not fit 4WD/AWD, pickups or compact Blazer/Jimmy. Confirm body style before ordering.
- This release covers 5.7L gasoline V8 applications. Diesel applications require a separate fitment review and are not included.
- Spindle kits fit approximately 1.25-inch-thick front rotors only, not 1-inch rotors. Measure before ordering. Minimum 16-inch wheels; verify wheel/tire clearance. Front track width increases approximately 1 inch per side.
- Professional installation and wheel alignment are required. Remove the factory alignment knockouts to permit fine adjustment. Check steering, suspension, brake-hose and ABS-wire clearance through the full range of motion.
- Aftermarket upper control arms are recommended with 2-3-inch front coil-spacer lifts. Upper control arms are not included. Verify bump-stop clearance and shock travel at full compression and extension.
- Grade 8 U-bolts, nuts and washers are included. Check the spring/plate stack, thread and clearance before tightening; bolts may need shortening. Lift amounts are approximate and vary with spring condition, equipment and load.
- Includes two front and two rear shocks with the specified mounting hardware. Confirm mount fit and full suspension travel during installation.
- Maximum wheel backspacing is 4.5 inches. Confirm wheel, tire and suspension clearance before use.
Items included
- Pair of 4-inch front lift spindles — 1.25-inch rotor application
- Pair of front coil spacers — 3-inch nominal lift
- Pair of 5-inch rear lift blocks
- 4 Grade 8 U-bolts
- 8 U-bolt nuts
- 8 U-bolt washers
- 2 front shocks (SCL0561)
- 2 rear shocks (LCL0092)
- 2 front BP25 bar pins; 2 rear BP285 bar pins
- 2 SHSL15 sleeves; 2 stem mounting-hardware kits
